JVC BR-HD50 - Manual (Page 35)

E-31
CONNECTION
Connecting the AC adapter
Connect the supplied AC adapter to BR-HD50.
Memo
z Even in the OPERATE OFF mode, a small
amount of electricity will still flow into the unit.
z When the unit is in the OPERATE OFF mode,
no operation can be performed except that of
the OPERATE buttons and cassette loading/
ejecting.
„ Always attach the supplied ferrite core
to the DC cord. (
XPage 29)
1.
Remove one screw on the back panel of the
unit, and remove the DC cord clamp.
2.
Connect the DC cord of the AC adapter to
the DC IN terminal of BR-HD50.
3.
To prevent accidental disconnection of the
DC cord, insert the DC cord into the clamp,
orient the clamp as shown in the figure
above, and secure the clamp to the unit.
Use the screw removed in step
1
above to
secure the clamp to the unit.
4.
Connect the supplied power cord to the AC
IN terminal of the AC adapter.
5.
Connect the power cord to the power out-
let.
• BR-HD50 is turned on and the OPERATE
indicator lights up in red.
(OPERATE OFF mode)
• If DC IN MODE of the SYSTEM [2/2] Menu
screen is set to “OPE ON”, the OPERATE
indicator will light up in green.
(OPERATE ON mode)
Note
z Supply power to BR-HD50 using the supplied AC adapter. Do not
use other power sources.
z Do not unplug the DC cord and/or the power cord during recording
or playback.
z If the supply voltage is low, an alarm display of “LOW VOLTAGE”
is shown.
Screw
1.
Clamp
Supplied AC adapter
Supplied power cord DC cord
DC IN terminal
3.
Clamp
2.
4.
5. Supplied ferrite core
OPERATE indicator
OPERATE
button
LOW VOLTAGE
Alarm message