JVC BR-HD50 - Manual (Page 45)

E-41
RECORDING
Settings for analog signal input
„ Selecting analog input signal
Set the INPUT SELECT switch located on the
front panel to LINE or Y/C.
LINE
: Inputs composite video from the
LINE IN terminal, and analog audio
signals from the AUDIO IN terminal.
Y/C : Inputs Y/C separate signals from
the Y/C IN terminal, and analog
audio signals from the AUDIO IN
terminal.
„ Setting VIDEO Menu screen
z SET UP [60]: DV (only for U model)
Set here according to the existence of the
setup of analog video signals (composite and
Y/C separate). If it exists, set here to ON. If it
does not, OFF.
„ Setting AUDIO Menu screen
z AUDIO MODE: DV (In DV mode only)
Selects the audio sampling frequency for
recording.
32k
: Records in 12-bit 32 kHz mode. DV
format has up to four channels of
recording tracks available, but this
unit only records onto two chan-
nels: CH1 and CH2.
48k : Records in 16-bit 48 kHz mode.
Records onto CH1 and CH2.
Memo
Audio dubbing is not available on this unit.
„ Setting SYSTEM Menu screen
z REC LONG P. TIME
This is for setting the time for BR-HD50 to
enter the tape protection mode if there is a
long recording pause.
z INDEX WRITE: SYSTEM [2/2] Menu
This is for selecting whether to record index
signals automatically when recording starts.
(SYSTEM menu details:
XPage 67 to 69)
„ For settings when recording time
codes, refer to pages 60 and 61.
INPUT SELECT switch
Setting Menu screens