JVC BR-HD50 - Manual (Page 60)

E-56
PLAYBACK
Multi cue-up
Using the time codes recorded on the tape, up to 5 points on the tape can be registered as cue-up
points at the Multi Cue-up screen. The registered tape positions (cue-up points) can be searched.
1.
Set the COUNTER switch to TC.
2.
Load a tape with time codes recorded.
3.
Press the CUE UP button.
The MULTI CUE UP screen appears on the monitor.
4.
Perform playback or search. At the position to be regis-
tered, set it to the STILL or STOP mode.
5.
Press the R or P button to bring the cursor to the cue-
up point. Press the SET button.
Register the time code data of the current position as a cue-
up point.
• If no tape is loaded, “00” is registered.
• Cue-up points can be registered while the tape is being
played back.
6.
To register more cue-up points, repeat steps
4
and
5
. Up to
5 cue-up points can be registered.
Press the R or P button to bring the cursor to the cue-up point
to be cleared. Press the RESET button.
After a cue-up point is cleared, “– –” is displayed.
Registering cue-up points
Clearing registered cue-up points
COUNTER swicth
R button RESET button
CUE UP button P button
SET button
– – – M U L T I C U E U P – – – – – –
C U E I 0 0 : 0 1 : 3 5 : 1 1
C U E 2 0 3 : 4 2 : 5 9 : 2 1
C U E 3 – – : – – : – – : – –
C U E 4 1 1 : 2 1 : 4 8 : 0 7
C U E 5 – – : – – : – – : – –
E X I T
“ S E T ” : E N T R Y C U E D A T A
“ R E S E T ” : C L E A R C U E D A T A
“ C U E U P ” : E X E C U T E C U E U P
MULTI CUE UP screen
Memo
For details on time code setting
and recording:
(
XPage 58)
Cursor
Cue-up point