JVC BR-HD50 - Manual (Page 28)

E-24
ON-SCREEN DISPLAY
Event/Alarm display
„ Event display : When certain functions are in use, it is displayed at the following posi-
tions (with the DISPLAY mode ON or AUTO).
z “A” display: displayed during operation
z “B” display: displayed for about 3 seconds
„ Alarm display : An alarm message is displayed at the following positions when there has
been an operation error or when BR-HD50 is not in good condition, e.g.,
dirty head.
z “A” display: The state of BR-HD50 is displayed. It continues to be displayed until the error state is
corrected. This display is not affected by the setting of the display mode.
3 D V 2 K C H – 1 / 2 S P 2 m i n 0
B L A N K S E A R C H
I N D E X D E T E C T E D
0 6 / 1 0 / 0 5 S T A N D B Y - O F F
1 1 : 2 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
A
B
Display Description
BLANK
SEARCH Blank search in progress.
INDEX +1 Index search in progress.
The number indicates the
index search position.
INDEX MARK When an index has been
specified on the tape during
recording.
Display Description
INDEX
DETECTED An index has been detected
during index repeat operation.
VIDEO END
DETECTED The video end has been
detected during end repeat
operation.
Display Description
LOW VOLTAGE The voltage of the DC power source is low. If the operation continues, it enters
the OPERATE OFF mode.
HEAD CLEANING
REQUIRED! The video head is dirty. Clean it with the head-cleaning tape exclusively for BR-
HD50. (
XPage 9)
If the head is clogged, it is detected in the PLAYBACK mode and this message is
displayed.
OVERHEATING! The temperature inside BR-HD50 has exceeded the stated value.
Disconnect the power and place it at a cool place. If this message is displayed
again, BR-HD50 could be defective.
Consult your JVC-authorized service agent.
3 D V 2 K C H – 1 / 2 S P 2 0
m i n
H E A D C L E A N I N G R E Q U I R E D !
N O H D V V D / S I G N A L
0 6 / 1 0 / 0 5 S T A N D B Y - O F F
1 1 : 2 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
A
B