Wiring and i/o, At a glance, Introduction – Schneider Electric Lexium 17S Series User Manual
Page 53
41
4
Wiring and I/O
At a Glance
Introduction
This chapter describes and illustrates all power wiring connections, all signal wiring
connections, and I/O wiring connections on the 17S drive. Power and signal wiring
connections are:
l
AC mains power through a four-position, plug-in, terminal block connector
l
Bias power through four-position, plug-in, terminal block connector
l
Serial power connections among multiple drives
l
Servo motor power through a six-position, plug-in, terminal block connector
l
Optional Regen power resistor through a four-position, plug-in, terminal
block connector
l
Resolver feedback input through a nine-pin, plug-in, Sub-D connector
l
Encoder feedback input through a 15-pin, plug-in, Sub-D connector
l
Auxiliary encoder interface through a nine-pin, plug-in, Sub-D connector
l
Fiber optic Interface through two SMA connectors
l
Analog in and digital I/O through an 18-position, plug-in terminal block
connector
l
Serial communications interface through a nine-pin, plug-in, Sub-D
connector
Continued on next page