Schneider Electric Lexium 17S Series - Manual (Page 78)

66
Serial Communications Connection
RS-232 Null
Modem Type
Communication
Connection
Diagram The following diagram depicts the RS-232 communication connection between the
Lexium 17S and a PC.
See wiring in Appendix C
The setting of the operating, position control, and motion-block parameters can be
carried out with an ordinary commercial PC.
Connect the PC interface (X6) of the servo amplifier while the supply to the
equipment is switched off via a normal commercial 3-core cable to a serial
interface on the PC. Do not use a null-modem link cable!
The interface is electrically isolated through an optocoupler, and is at the same
potential as the CANopen interface.