Schneider Electric Lexium 17S Series - Manual (Page 85)

73
Front Panel Controls and Indicators
Keypad
Operation The operation of the keypad on the front panel of the 17S drive is described in the
following table. The two keys can be used (as an alternative to using the PC) to
specify and enter the SERCOS address for the drive.
Note: The drive must be powered down then powered up again to confirm an
address change.
LED Display The alphanumeric display indicates drive power status conditions, error codes and
warning codes. The power status conditions are shown below; error and warning
codes are identified and described in the Troubleshooting chapter.
Continued on next page
Key Function
Press once: Increments address by 1
Press twice in rapid succession: Increments address by 10
Press once: Decrements address by 1
Press twice in rapid succession: Decrements address by 10
Press and hold right key, then press left key: Enters the
address specified above.