Siemens CP 243-2 - Manual (Page 136)

AS-Interface Protocol Implementation
A-2
SIMATIC NET CP 243-2 AS-i Master
C79000-G8976-C142/02
Table A-2 , continued
No. Comment / Function implemented by /
Section M1 Function or Call on the Host Interface
(symbolic representation)
10 Status = Store_Actual_Configuration() X By pressing the SET button; or with the
command
Store_actual_configuration
see Section 5.2.4
11 Status, Config =
Read_Actual_Configuration(Addr) X Get_Extended_Actual_Configuration / see
Section 5.2.9
12 Status = Set_LPS(List31) X Set_LPS / see Section 5.2.10
13 Status, List31 = Get_LPS() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
14 Status, List31 = Get_LAS() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
15 Status, List32 = Get_LDS() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.0 Status = Get_Flags() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.1 Status, Flag = Get_Flag_Config_OK() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.2 Status, Flag = Get_Flag_LDS.0() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.3 Status, Flag =
Get_Flag_Auto_Address_Assign() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.4 Status, Flag =
Get_Flag_Auto_Prog_Available() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.5 Status, Flag =
Get_Flag_Configuration_Active() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.6 Status, Flag =
Get_Flag_Normal_Operation_Active() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.7 Status, Flag = Get_Flag_APF() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
16.8 Status, Flag = Get_Flag_Offline_Ready() X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
17 Status = Set_Operation_Mode(Mode) X By pressing the SET button; or with the
command
Set_operation_mode
see Section 5.2.13
18 Status = Set_Offline_Mode(Mode) X see Section 5.2.11
19 Status = Activate_Data_Exchange(Mode) – not implemented