System functions, Configuring determination of costs – Siemens Gigaset 75 User Manual
Page 45
41
System functions
Gigaset 3070/3075isdn, GB, A31008-G3070-B100-3-7619
giga3070KAP.fm
09.01.01
Step
by
Step
Activating/deactivating charge display for the previous call
With Gigaset Comfort/Classic telephones, pressing the
D
key lets you dis-
play the costs/units accumulated for the previous call at the telephone.
Press
for selection menus.
Select using [
] and [OK]:
Service Set up
→
Settings
→
System settings
→
Cost/duration
.
Enter the base PIN and confirm with [OK].
Select using [
] and [OK]:
Last charge
,
Call Duration
are deactivated.
Configuring determination of costs
Providers today no longer have to transmit call charges in units. They can also
immediately transmit the currency amount. This option will become more
widespread in the near future.
Gigaset 3070/75isdn can detect the changeover on the network side from units
to charges or vice versa. The user is then requested to switch over this option
manually. The available options are: "Units Cent.Off.", "Costs Cent.Off.", "No
Rate", "Rate --.--" and "Rate ----". "Units Cent.Off." is active as standard.
The factor relates to both "Units Cent.Off." and "Costs Cent.Off.". Thus with a
factor of 0.20, when "Units Cent.Off." is set, for example, each unit should cost
0.20 DM. If "Costs Cent.Off." is set, costs should only be assigned the factor
0.2 - in this case this would mean that 80% of the call charges would not be
recorded.
With factors < 1 and the setting "Costs Cent.Off.", the amount displayed does
not cover the call charges.
●
Before the charges for each call can be calculated, the currency and price per
unit must be defined.
Entering the price per unit
Press
for selection menus.
Select using [
] and [OK]:
Service Set up
→
Settings
→
System settings
→
Cost/duration
.
Enter the PIN and confirm with [OK].
Select using [
] and [OK]:
Access type
.
Select using [
] and [
'
]:
Rate --.--
(with decimal point) or
Rate ----
(without decimal point).
Enter the basic price and confirm with [
'
].
Select using [
] and [OK]:
Save entry
.
If you would like to set an additional currency:
Enter the currency and confirm [
'
].
Select using [
] and [OK]:
Save entry
.
If [No Rate ] was already set a prompt is displayed.
Confirm the prompt for accounting method with [YES].
All accounts are reset and the option is highlighted.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.