Siemens Gigaset 75 - Manual (Page 50)

46
Answering machine (3075isdn only)
Gigaset 3070/3075isdn, GB, A31008-G3070-B100-3-7619 giga3070KAP.fm 09.01.01
Step
by
Step
Modifying settings
Defining the number of rings
Factory setting: automatic 2/4. In this case the answering machine operates as
follows: if there are no messages, the announcement is activated after 4 ring
cycles; if messages have already been left, the announcement is activated after
2 cycles. When you check your messages remotely, this enables you to tell af-
ter 3 ring tones that there are no new messages. If you hang up immediately,
no call charges are incurred.
Press  for selection menus.
Select using [ ˆ ] and [OK]: Service Set up → Answ. Machine → (required AM)
→
Settings
→
No. of Rings
→
( 1-9 ) or ( Automatic 2/4 ).
Activating/deactivating output of the date and time
If the time stamp is activated, all messages include the day, date and time of
recording.
Press  for selection menus.
Select using [ ˆ ] and [OK]: Service Set up
→
Answ. Machine
→
(required AM)
→ Settings → Message/Memo → Time Stamp .
Defining recording length
The message can either be 1 minute, 2 minutes or 3 minutes long, or of max-
imum length.
Press  for selection menus.
Select using [ ˆ ] and [OK]: Service Set up → Answ. Machine → (required AM)
→
Settings
→
Message/Memo
→
Message Length
→
(r equired recording
length ).
Setting recording quality
If you set the recording quality to EXTRA-high, this reduces the available re-
cording time. At standard recording quality (which is normally sufficient), the
memory can support 35 minutes, at high quality 12 minutes.
Press  for selection menus.
Select using [ ˆ ] and [OK]: Service Set up
→
Answ. Machine
→
(required AM)
→ Settings → AM Quality → High quality or Long recording.
Remote control
You can also operate your answering machine externally, e.g to play back and
delete messages. To do this you must modify the answering machine PIN
(factory setting: 0000) to ensure maximum security. To ensure full functionality
for this type of operation, remote control and remote delete must be enabled.
1.
2.
1.
2.
1.
2.
1.
2.