Siemens Gigaset 75 - Manual (Page 61)

57
Operation with other devices
Gigaset 3070/3075isdn, GB, A31008-G3070-B100-3-7619 giga3070KAP.fm 09.01.01
Step
by
Step
Operation with other devices
For information on operation and call number assignment, please refer to ”Reg-
istering other devices“ on page 7.
Registering a Gigaset 3000 Classic handset
®x{ <Base No.> [OK]<System Code>[OK] < press green illuminated key on
base station >, <INT No.>
Registering the Gigaset 2000S handset
Handset 0 (off), press <Base No> and 0 (on) simultaneously, System Code 
<press green illuminated key on base station> ( internal number is assigned automatically
by the base station )
Normal telephone (POT)
This connection must be enabled before a normal telephone (POT) can be put
into service, see "Setting the device type" on page 20.
Registering third-party GAP handsets
Press the green illuminated key on the base station.
Prepare the GAP handset for registration (see the handset operating instruc-
tions). A connection is setup between the base station and the GAP handset.
The GAP handset is assigned the lowest available internal number. An available
internal number cannot be selected via the GAP handset.
The display depends on the GAP handset used, as the base station does not
send display information to GAP handsets.
Activating and deactivating the repeater capability
The Gigaset repeater allows you to double the range of your handset and can
be used as an accessory for Gigaset 3070/3075isdn. This function allows you
to activate and deactivate the repeater capability.
Further information can be found in the operating instructions for the Gigaset
repeater.
Press  for selection menus.
Select using [ ˆ ] and [OK]: Service Set up
→
Settings
→
System settings
→
Spec. function → Repeater .
Set using [OK]:
9EHIRUHWKHPHQXFRPPDQG
= ON / no
9
= OFF
7RDFWLYDWHSUHVV
[NEXT]. The handset is then temporarily disabled. To switch
back, press

[BACK]

1.
2.
Info
1.
2.
3.
4.