Sony DFS-700 - Manual (Page 124)

Chapter 5 Control From Editing
Control Units
5-10
Chapter 5 Control From Editing Control Units
Notes on Operation
Editing point delay
Because the DFS-700/700P has a built-in frame synchronizer, output of
player VCR edit points set on the BVE-900/910/2000 is delayed by 1
frame, so that recording begins with the previous frame. However,
recorder edit points are not delayed.
Example: If the IN point of the player VCR is set to 00:00:10:15,
recording begins from 00:00:10:14.
If you are using a BVE-2000 with a ROM version of 2.00 or higher, in
SYSTEM SETUP mode under SYSTEM CONFIGURATION you can set
the DIGITAL EFFECT DELAY item to 01 so that the BVE-2000
compensates for the delay automatically.
Executing effects in the reverse direction
• To execute an effect in the reverse direction from the BVE-900/910, add
3000 to the DFS-700/700P effect pattern number. However, add 500 to
the pattern numbers of user program effects (pattern numbers 9000 and
above).
Examples:
To execute effect 25 in the reverse direction, specify pattern number
3025.
To execute effect 9203 in the reverse direction, specify pattern number
9703.
• To execute an effect in the reverse direction from the BVE-2000, add a
minus sign (–) before the DFS-700/700P pattern number.
Example:
To execute effect 25 in the reverse direction, specify effect pattern
number –25.
Effect intervals
Effects cannot be executed if there is no interval between transitions, as
shown below in figure (a).
Be sure to leave an interval of at least two frames or more between
transitions, as shown in figure (b).
Minimum interval between transitions
(a)
IN OUT IN OUT
(b)
Transition Transition Transition Transition At least two
frames
Control From the BVE-900/2000 Series