Sony DFS-700 - Manual (Page 136)

Chapter 6 System Connections and
Settings
6-8
Chapter 6 System Connections and Settings
System Information Display (page 2/8)
Input Video Setup (page 3/8)
Button Setting Meaning Values
F1 INFO Display options installed. CONFIG r BKDF-701/711/712
(Appears as “***” when not installed.)
To return, press F5(EXIT
r ).
F2 INFO Display software version. VER r DFS-700/700P :x.xx
BKDF-712: x.xx
DATA: x.xx
Panel: x.xx
(Appears as “----” when not installed.)
To return, press F5(EXIT
r ).
F3 PW ON Select setup mode at power on. FACTRY (factory default)/USER (user
settings)
F5 INSTL Install new software. r Press F3(OK) to confirm install; press
F5(CANCEL) to cancel.
Button Setting Meaning Values (First value is factory default.)
F1 In No. Select input to set. 1/2/3/4/5/6/7/8/DSK
F2 TYPE Select input signal format. SDI/YUV/Cps/YC/RGB/***
(Only types which can be set appear.
See the table
on the next page. When F1(In No.) is set to DSK,
appears as “***”.)
F3 TBC TBC Center setting for the input
signal
The output signal is output in the
correct phase if the phase
relationship of the center value with
respect to the reference
synchronizing signal is in the range
±0.3H. 0H/0.5H/1H/***
This setting is not possible when TYPE is Cps or
YC.
F4 +H–pos Video phase adjustment of input
signal • When SDI, YUV, Cps, YC, or RGB is selected, this
can be adjusted from –24 to +24 in steps of 2.
• When DSK is selected, this can be adjusted from
–32 to +31 in steps of 1.
F5 +XPT Cross-point button assignment to
input signals
Setup Menu Settings
1/2/3/4/5/6/7/8/***
(When F1(In No.) is set to DSK, appears as “***”.)
To assign a signal, hold down the function key, and
press a cross-point button on the background bus.