Sony DFS-700 - Manual (Page 63)

Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-37
Auto chroma keying
To combine the background image and foreground image by auto chroma
keying, use the following procedure.
1
Select the background image with the BACKGROUND bus buttons.
The selected background image appears on the program monitor.
2
Select the foreground image with the FOREGROUND bus buttons.
If a preview monitor is connected, the selected foreground image
appears in the preview monitor.
3
Select the effect pattern, and press the TITLE button in the effect
transition section, turning it on.
Note
Depending on the effect pattern, it may not be possible to use chroma
keying. If such a pattern is selected, the TITLE button does not light.
Check the “TITLE” column of the table in the section “Effect Pattern
Variant Forms and Decorations” (page A-22), and select a pattern for
which this shows a check mark ( ).
When the TITLE button lights, the N/R button also automatically
lights, indicating that the system is in N/R (normal/reverse) mode.
While the TITLE button is lit, it is not possible to switch out of N/R
mode.
LAST X
INS
RST
TITLE 1 2
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDER BEVELD EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDER MATTES LOCATION
LEARN EDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN
ADJ
PAGE F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB SET
TRANS RATE
7 8 9
4 5 6
1 2 3
0
DOWN UP ENTER
FADE
TO BLACK
P IN P DSK
DEL
N/R REV DSK PVW DIRECT
RECALL DIRECT PATTERN CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE 1 2 3 4 5 6 7 8
CUT
AUTO
TRANS
AUXILIARY
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
FOREGROUND
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
PATTERN/KEY PAD
3
5,7
6 4
1
2
(continued)