Sony DFS-700 - Manual (Page 28)

Chapter 3 Basic Operation
3-2
Chapter 3 Basic Operation
Example Operation (1): Wipe
In this example we’ll use the AUTO TRANS button, to make a wipe, with
the new image appearing from the center of the screen.
Setting items
As an example, we’ll set the control panel as follows.
Background image (the image output before the transition): video
signal connected to the VIDEO INPUT 1 connector
Foreground image (the image output after the transition): video
signal connected to the VIDEO INPUT 2 connector
Effect: wipe (pattern number 24)
Transition time: 30 frames
Program output
Executing the above effect produces the following changes in the output
on a program monitor connected to the PGM OUT connector of the
processor unit.
DME Switcher Introduction
Start of effect
Transition time
End of effect