Sony DFS-700 - Manual (Page 77)

Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-51
Setting Up a Transition
This section describes how to set the transition time and transition
direction.
Setting the Transition Time
The transition time measures the duration of an effect in frames (1/30
second (NTSC) or 1/25 second (PAL)), ranging from 0 to 999 frames.
In this system, you can set the transition time for a downstream key or
fade-to-black independently of the transition time for an effect.
Procedure
To set the transition time, use the following procedure.
1
Press the SET button in the effect transition section until the
appropriate display window mode indicator (EFFECT, DSK, or FTB)
is lit.
EFFECT: for setting the effect transition time
DSK: for setting the downstream key transition time
FTB: for setting the fade-to-black transition time
Note
If the EDIT button in the user program section is lit, it is not possible
to set the transition time. Press the EDIT button, turning it off.
2
With buttons 0 to 9 in the pattern/numeric keypad, enter the desired
transition time (0 to 999 frames).
The value entered appears in the TRANS RATE display window, and
dots appear to the lower right of the digits. You can use the UP and
DOWN buttons to adjust the value.
LAST X
INS
RST
TITLE 1 2
EDITOR LUM LUM LUM
DSK EDGE
TRAIL SHADOW
GPI CRK CRK BORDER BEVELD EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDER MATTES LOCATION
LEARN EDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN ADJ PAGE F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB SET
TRANS RATE
7 8 9
4 5 6
1 2 3
0 DOWN UP ENTER
FADE TO
BLACK
P IN P DSK
DEL
N/R REV DSK PVW DIRECT
RECALL DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE 1 2 3 4 5 6 7 8
CUT
AUTO
TRANS
AUXILIARY
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
FOREGROUND
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
PATTERN/KEY PAD
3
2
1
(continued)