Sony DFS-700 - Manual (Page 60)

Chapter 3 Basic Operation
3-34
Chapter 3 Basic Operation
Procedure
To insert text and graphics in a background image by means of a
luminance key, use the following procedure.
1
With the BACKGROUND bus buttons, select the background image.
The selected background image appears on the program monitor.
2
With the FOREGROUND bus buttons, select the foreground image.
If a preview monitor is connected, the selected foreground image
appears in the preview monitor.
3
Select the effect pattern, and press the TITLE button in the effect
transition section, turning it on.
Note
Depending on the effect pattern, it may not be possible to use a
luminance key. If such a pattern is selected, the TITLE button does not
light. Check the “TITLE” column of the table in the section “Effect
Pattern Variant Forms and Decorations” (page A-22), and select a
pattern for which this shows a check mark ( ).
When the TITLE button lights, the N/R button also automatically
lights, indicating that the system is in N/R (normal/reverse) mode.
While the TITLE button is lit, it is not possible to switch out of N/R
mode.
LAST X
INS
RST
TITLE 1 2
EDITOR LUM LUM LUM
DSK EDGE
TRAIL SHADOW
GPI CRK CRK BORDER BEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDER MATTES LOCATION
LEARN EDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN ADJ PAGE F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB SET
TRANS RATE
7 8 9
4 5 6
1 2 3
0 DOWN UP ENTER
FADE TO
BLACK
P IN P DSK
DEL
N/R REV DSK PVW DIRECT
RECALL DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE 1 2 3 4 5 6 7 8
CUT
AUTO
TRANS
AUXILIARY
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
FOREGROUND
BLACK MEMORY INT
VIDEO 1 2 3 4 5 6 7 8
PATTERN/KEY PAD
3
6 4
1
2
5
Inserting Characters and Graphics (1) — Title Key