Sierra INNOVA-FLO 220 - Manual (Page 39)

Chapter 3 Operation Series 220/221 Instruction Manual
Start-Up
To begin flow meter operation:
Note
Starting the flow meter
or pressing EXIT will
always display the Run
Mode screens.
1. Verify the flow meter is installed and wired as described in Chapter
2.
2. Apply power to the meter. At start up, the unit runs a series of self-
tests that check the program configuration and all flow sensing com-
ponents. After completing the self-test sequence, the Run Mode
screens appear.
3. The Run Mode displays flow information as determined by settings en-
tered in the Display Menu (page 3-5). Press the ×Ø arrow keys to
view the Run Mode screens.
Press the ENTER key from any Run Mode screen to access the Setup
Menus. Use the Setup Menus to configure the meter’s multi-parameter
features to fit your application.
Setup
Menus
Password
ENTER
Mass Flow
Rate
Volume
Flow Rate
Total
ENTER
Press EXIT to return
to Run Mode
Use
keys to access
each item
Run Mode
Screens
To operate the six push buttons through the
display enclosure, use the hand held magnet
as shown at right.
3-2 IM-22