Sierra INNOVA-FLO 220 - Manual (Page 40)

Series 220/221 Instruction Manual Chapter 3 Operation
Using the Setup Menus
Output
Menu
Display
Menu
Totalizer
Menu
Units
Menu
Diagnostics
Menu
Calibration
Menu
Password
Menu
Password
4-20 mA
Output 1
ENTER
Cycle Time
(sec)
Number of
Digits
Display TC
(sec)
Display
VFlow?
Display
MFlow?
Totaling
Unit per
Pulse
Reset Total
Mass Flow
Unit
Volume
Flow Unit
Sim Vor
Freq
Highest
Velocity
Meter Size
or Pipe ID
Meter Factor
Process
Temp (F)
Density
Ref Density
Set
Password
Serial
Number
Mass Flow
Rate
Volume
Flow Rate
Total
ENTER
Run Mode
Screens
Setup Menus
Display
Total?
Viscosity
Vortek Coef
Ck
Low Flow
Cutoff
Programming the Flow Meter
1. Enter the Setup Menu by pressing the ENTER key until prompted for a password. (All
outputs are disabled while using the Setup Menus.)
2. Use the ЧШХЦ keys to select the password characters (1234 is the factory-set
password). When the password is correctly displayed, press ENTER to continue.
3. Use the Setup Menus described on the following pages to customize the multi-
parameter features of your Innova-Flo Vortex Meter. (The entire lower display line is
available for entering parameters.)
4. To activate a parameter, press ENTER. Use the ЧШХЦ keys to make selections. Press
ENTER to continue. Press EXIT to save or discard changes and return to Run Mode.
IM-22 3-3