Sun Microsystems Sun Fire V100 - Manual (Page 105)

Chapter 8 Removing and Replacing Components 87
4. Replace the zip tie on the new system.
5. Power on the new system (see Chapter 4).
Caution – Never remove the system configuration card when the server is booting
or running Solaris. Power the server off or down to standby mode before removing
or inserting the system configuration card.
Caution – Do not handle the system configuration card unless you need to transfer
it to another system. If you need to handle it for this reason, avoid contact with the
gold terminals on the underside of the card.
FIGURE 8-1 The System Configuration Card Slot
Adding or Changing Internal
Components
The procedures in this section are for the attention of qualified service engineers
only. If you need to replace or add a component, contact your local Sun sales
representative, who will put you in touch with the Sun Enterprise Service branch for