Sun Microsystems Sun Fire V100 - Manual (Page 70)

52 Sun Fire V100 Server User’s Guide • December 2001
▼ To View the Entire Event Log
● Type:
where x is the number of lines you want to display before pausing, and y is the
severity level of the events you want to see. By default, the
loghistory command
displays all the events in the log and does not pause the display.
If you specify a severity level, you will see reports for the level you specify and
above. For example, if you specify level 2, you will see reports of level 2 and level 1
events. If you specify level 3, you will see reports of level 3, level 2, and level 1
events.
If you do not specify a level, you will see events for all levels.
For more information about severity levels, see “Viewing Event Reports That LOM
Sends to syslogd” on page 61.
Each entry in the log includes the time of the event, the server’s host name, a unique
identifier for the event, and a user-friendly text message describing the event.
Note – The LOM device’s Event Log is never cleared, and it can contain several
hundred entries. Events are stored from the very first time the server boots.
Eventually the buffer might become full, but when this happens, the LOM device
will start again at the beginning of the buffer, overwriting the earliest events.
▼ To View All Events From the First to the nth
Event Logged
● Type:
where n is the number of events you want to see that have been logged since the first
event in the current log, x is the number of lines you want to display before pausing,
and y is the severity level of the events you want to see. By default, the
loghistory
command does not pause the display.
lom> loghistory [pause x ] [level y ]
lom> loghistory index + n [pause x ] [level y ]