Sun Microsystems Sun Fire V100 - Manual (Page 111)

Chapter 8 Removing and Replacing Components 93
■ If the server is already in use, see “To Change Components In a Sun Fire V100
Server That Is In Use” on page 88.
1. Place the unit on an ESD surface and attach an antistatic wrist strap (see
FIGURE 8-2 ).
2. Remove the server’s top cover (see “To Remove the Top Cover” on page 89).
3. Remove the metal placeholder if your server has one (if it was configured with a
single hard disk drive, the second hard disk drive slot will have the placeholder
installed).
FIGURE 8-7 Removing the HDD Placeholder
4. Insert and align the new hard disk drive (see FIGURE 8-8 ).
a. Position HDD and slide onto the clips on the base of the server.
b. Press the handle into the two clips on the base of the server.