Sun Microsystems Sun Fire V100 - Manual (Page 75)

Chapter 5 Managing the Sun Fire V100 Server From the lom> Prompt 57
By default, all four areas of authorization are available to each named user you set
up. You can limit users to a particular area or areas of authorization by specifying
permissions for a named user.
▼ To Specify Permissions for a Named User
● Type:
You can specify:
■ All four parameters (for example, userperm cuar )
This also makes all four areas available to the named user.
■ One, two, or three parameters
This makes only the parameter or parameters you specify available.
The parameters are:
■ c
This stands for “console permission”. It enables the named user to exit from the
lom> prompt to the Solaris prompt (as long as the Serial A/LOM port is shared
between LOM and the console).
■ u
This stands for “user administration permission”. It enables the named user to
add and delete users and alter their areas of authorization by using the
userperm
command.
■ a
This stands for “administration permission”. It enables the named user to change
the LOM device’s configuration variables (see “Setting the LOM Configurable
Variables” on page 58).
■ r
This stands for “reset permission”. It enables the user you have named to reset
the server and to power it on and off using the LOM device.
■ -
Use this character to specify that no permissions are assigned.
lom> userperm username [c][u][a][r][-]