Sun Microsystems Sun Fire V100 - Manual (Page 139)

Appendix B Configuring LOM Driver 121
Configuring the LOM Device Driver
The full list of parameters you can set in this file is given in TABLE B-1 .
TABLE B-1 LOM Configuration File Parameters
Field Format Default Effect
wdog_reset= Boolean
0=FALSE
1=TRUE 0 Causes LOM to reset the server
after a watchdog timeout.
Setting this to 1 is equivalent to
using the
lom -R on command
described in Chapter 6.
wdog_alarm3= Boolean
0=FALSE
1=TRUE 0 Turns on software alarm 3 when
the LOM watchdog times out.
Setting this to 1 is equivalent to
using the
lom -A on,3
command described in
Chapter 6.
serial_events= 0=OFF
1=ON
2=ON
WHEN
DRIVER
NOT
LOADED 2 Causes LOM to report events
over the serial connection.
Setting this parameter to 0
means that no events will be
reported over the serial
connection. Setting it to 1 means
that events will be reported
over the serial connection as
well as to
syslogd ; this is
equivalent to lom -E on . If
you have dedicated the Serial
A/LOM port to LOM, you need
to set this parameter to 1. It
ensures that you receive all
event reports at the terminal
you have connected to Serial A/
LOM. Finally, setting the
parameter to 2 means that
events will be reported over the
serial connection but only when
the driver is not running (when
it is running they will be
reported to
syslogd , although
Fatal and Warning messages
will still go to Serial A/LOM).