Kyocera FS-C8008DN - Manual (Page 105)

3.9 Operating the Storage Device
3-60
3.9 Operating the Storage Device
The printer supports three types of storage device; memory card, option hard disk, and
RAM disk. The memory card and option hard disk are installed into the dedicated slots of
the printer. The RAM disk is an allocated part of the printer’s memory. If the optional hard
disk is installed in the printer, the e-MPS function will be available. For details, see
e-MPS
on page 3-20 .
The basic operations of each storage device are the same. This section mainly explains the
operation of the memory card.
3.9.1 Using the Memory Card
The printer is equipped with a slot for a memory card. By inserting a memory card into the
printer, the following operations become available.
• Reading Font Data
• Reading Data
• Writing Data
• Deleting Data
• Formatting Memory Card
• Printing a List of Data Names
For details about the handling of the memory card, see Appendix A Options, section A.3.1
Memory Card on page A-7 .
Reading Font Data
In case of a memory card if a memory with the font data card is already inserted into the slot
when the printer is turned on, the fonts are automatically read into the printer. To read fonts
into the printer from a memory card, proceed as follows.
1 11 1
Press the MENU key.
2 22 2
Press the U or V key repeatedly until Memory Card > appears.
3 33 3
Press the Z key.
4 44 4
Press the U or V key repeatedly until >Read Fonts appears.
5 55 5
Press the ENTER key. A question mark (?) appears.
Memory Card >
>Read Fonts
>Read Fonts ?