Kyocera FS-C8008DN - Manual (Page 139)

3.13 Other Modes
3-94
3.13.6 Resource Protection
By default, when you switch from the PCL 6 emulation to another, all downloaded fonts and
macros will be lost. Resource protection preserves these PCL resources in memory so that
they remain intact even when you have switched back in PCL 6.
Note
Resource protection requires extra memory to store the downloaded fonts and
macros. The total size of the printer memory recommended for using the resource
protection option is affected by several factors. See
Appendix A Options .
By default, resource protection is deactivated. To activate resource protection, proceed as
follows:
1 11 1
Press the MENU key.
2 22 2
Press the U or V key repeatedly until Others > appears.
3 33 3
Press the Z key.
4 44 4
Press the U or V key repeatedly until >Resource Prot. appears.
5 55 5
Press the ENTER key. A blinking question mark (?) appears.
6 66 6
Press the U or V key to select Permanent or Perm / Temp (Permanent/
Temporary) for resource protection.
7 77 7
When the desired resource protection is displayed, press the ENTER key.
8 88 8
To exit the menu selection, press the MENU key.
Others >
>Resouce Prot.
Off
>Resouce Prot.
? Off