Sleep – Kyocera FS-C8008DN User Manual
Page 136
3.13 Other Modes
3-91
Sleep Timer Timeout Time
You can adjust the timer timeout time, the length of time the printer waits before entering
sleeping mode in the absence of data. The default sleep timer timeout time is 30 minutes.
The printer reverts to normal operation mode when the printer receives a print job, the
operator panel is operated, or one of the exterior covers is opened.
Note
Color calibration is automatically executed before the printer reverts to normal
operation mode.
To confirm and change the timeout time, proceed as follows:
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others > appears.
3
33
3
Press the Z key.
4
44
4
Press the U or V key repeatedly until >Sleep Timer > appears.
5
55
5
To change the timeout time, press the ENTER key. A blinking cursor (_) appears.
6
66
6
Press the U or V key to increase or decrease the value at the blinking cursor and set
the desired time. The timer can be set between 5 and 240 min, in 5-minute
increments. Use the Z and Y keys to move the cursor right and left.
7
77
7
When the desired timeout time is displayed, press the ENTER key.
8
88
8
To exit the menu selection, press the MENU key.
Others >
>Sleep Timer >
030min.
>Sleep Timer
030min.