Kyocera FS-C8008DN User Manual
Page 198
Advertising
B.1 Parallel Interface
B-4
30
—
Ground return
31
In
— [nInit]
Ignored
32
Out Error
[nFault]
When the high-speed parallel line control is on, this line
returns an error status.
33
—
—
Not used
34
—
—
Not used
35
Out Power Ready
This signal goes high when the printer is powered on.
36
In
Select In [nSelect In]
When this line is high, IEEE1284 mode is enabled.
†
Indicates signals that are low active.
††
The Paper Empty, Online, and Error signals work only after you have enabled them using the O2
parameter of the FRPO command.
Pin
In or
out
Signal
Description
Table B-2
Advertising