8 auto continue setting, Auto continue setting -96 – Kyocera FS-C8008DN User Manual
Page 141
3.13 Other Modes
3-96
3.13.8
Auto Continue Setting
If an error that still allows you to continue printing occurs (Memory overflow Press
GO
, Print overrun Press GO, KPDL error Press GO, File not found
Press GO
, RAM disk error Press GO, MemoryCard err Press GO, Hard
disk err Press GO
, and Duplex disabled Press GO), the next received data
is automatically printed after a set period of time elapses. For example, if the printer is
shared over a network as a network printer and one person causes one of the above errors,
after the set period of time elapses, the data sent from the next person is printed. The default
setting is Off (Auto Continue disabled).
Note
For setting the auto continue recovery time, see the next section.
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others > appears.
3
33
3
Press the Z key
4
44
4
Press the U or V key repeatedly until Auto Continue > appears.
5
55
5
Press the ENTER key. A blinking question mark (?) appears.
6
66
6
Select On or Off using the U or V key.
7
77
7
Press the ENTER key.
8
88
8
To exit the menu selection, press the MENU key. The display returns to Ready.
Others >
>Auto Continue >
Mode Off
>Auto Continue
Mode ? Off