Kodak DCS600 - Manual (Page 241)

13-36
10 Drive rate in C L (DCS 620 and 620x only)
At the default setting, the frame rate is 2.0 fps.
To change the frame rate to 2.5 fps, select 10-1.
Custom Setting #10 is not available on the DCS
660 or 660M. The frame rate is always 0.15 fps.
2.0 fps 10-0
2.5 fps 10-1
11 Alert LED in buLb exposure:
To enable the alert LED to blink during buLb
exposure, select 11-1.
Does not blink 11-0
Blinks 11-1
12 Reserved 12-0
13 Reserved 13-0
14 Center-Weighted Metering:
In Center-Weighted Metering, 75% of the
meter’s sensitivity is concentrated in the
12 mm-diameter circle within the viewfinder
and 25% of the sensitivity is outside this circle.
To change the size of the circle to 8 mm,
12 mm, 15 mm, 20 mm diameter, or to the
average of the entire viewfinder, select C 8, C
15, C 15, C 20, or A.
Default: 75%
concentration in
12 mm diameter
area 14-0
75%
concentration in 8
mm, 12 mm, 15
mm, 20 mm
diameter area. C8,
C12,
C15,
C20, A
15 Time delay for auto meter-switch-off:
The camera meter remains on approximately 8
seconds after the Shutter Release button is
pressed. To change the delay time to 4, 16, or 32
seconds, select L 4, L 8, L 16 or L 32.
Default: 8
seconds 15-0
4, 8, 16, 32
seconds L4, L8,
L16,
L32
16 Self-timer duration:
At the default setting, the shutter is released 10
seconds after the Shutter Release button is fully
depressed. To change the delay time to 2 to 60
seconds in one second steps, select L 2, L 3,
L 4, … or L60.
Default: 10
seconds 16-0
2 to 60 seconds L2, L3,
L4, …,
L60
Number Function Your Option
LCD
Panel