Kodak DCS300 - Manual (Page 37)

1-25
1
Y
our
C
a
me
ra
Flash Sync Terminal
The flash sync terminal, only available with the DCS 330 camera, will trigger a flash that
uses a standard X-Sync cord. Refer to “Flash Sync Terminal” on page 8-26.
☛
The Sync flash cord/connector set is not supplied with the camera.
Serial Port Jack
The Serial Port jack, only available with the DCS 330 camera, is reserved for future
applications. It has a soft rubber cover (not shown). Do not remove the cover or plug
anything into the jack.
WARNINGS:
Flashes with a trigger circuit
voltage greater than 30V DC
will damage your camera and
can be hazardous.
The Flash Sync terminal is for
a flash sync cable system
ONLY! DO NOT CONNECT
AC MAIN POWER TO THIS
CONNECTOR!
SET
FNC
( )
MDE
Ps
BUSY
RESET +/-