Lexmark 382 - Manual (Page 163)

<color> Low
Replace the toner cartridge, and then wait for the message to clear.
Dialing
A fax number is dialed. If the number is too long to fit on the screen, only the word Dialing appears. Wait for the
message to clear.
DO NOT TOUCH
The printer is receiving a code to update a file. Wait for the message to clear.
Warning—Potential Damage: Do not turn off or touch the printer while this message appears on the display.
Fax complete
A fax that was sent or received is complete. Wait for the message to clear.
Fax failed
The fax failed to be sent. Wait for the message to clear.
Flushing buffer
Wait for the message to clear.
File corrupt
A file with a valid extension is detected, but the actual file type does not match the extension, or the file is corrupt.
Hex Trace
The printer is in Hex Trace mode.
With Hex Trace selected, all data sent to the printer is printed in hexadecimal and character representation. This is
used to help isolate the source of a print job problem.
Note: Control codes are not executed.
To exit Hex Trace, turn the printer off, wait about 10 seconds, and then turn the printer on.
Imaging Kit
Replace the imaging kit, and then press to clear the message and continue printing.
Incoming call
This message appears when using manual fax mode. Press to print a black only fax or to print a color fax.
Insert Tray <x>
Insert the specified tray into the printer.
Understanding printer messages
163