Lexmark 382 - Manual (Page 216)

T
HE TONER MAY BE LOW
88 <color> toner low appears when the toner is low.
Can receive but not send faxes
These are possible solutions. Try one or more of the following:
M
AKE SURE THE PRINTER IS IN
F
AX MODE
From the printer control panel, press the Fax button to put the printer in Fax mode.
M
AKE SURE THE DOCUMENT IS LOADED PROPERLY
Load the original document faceup, short edge first into the ADF or facedown on the scanner glass in the upper
left corner.
Note: Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine
clippings) into the ADF. Place these items on the scanner glass.
M
AKE SURE THE SHORTCUT NUMBER IS SET UP PROPERLY
• Check to make sure the shortcut number has been programmed for the number that you want to dial.
• As an alternative, dial the telephone number manually.
Received fax has poor print quality
These are possible solutions. Try one or more of the following:
R
E
-
SEND THE DOCUMENT
Ask the person who sent you the fax to:
• Check that the quality of the original document is satisfactory.
• Resend the fax. There may have been a problem with the quality of the telephone line connection.
• Increase the fax scan resolution, if possible.
T
HE TONER MAY BE LOW
When 88 <color> toner low appears or when you experience faded print, replace the cartridge(s).
M
AKE SURE THE FAX TRANSMISSION SPEED IS NOT SET TOO HIGH
Decrease the incoming fax transmission speed:
1 Type the printer IP address into the address field of your Web browser.
Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address
in the TCP/IP section.
2 Click Configuration.
3 Click Fax Settings.
Troubleshooting
216