Paradyne 4200 - Manual (Page 197)

10. Fault Commands
4200-A2-GB20-00 August 2002 10-5
RTRV-ALM-ALL
The RTRV-ALM-ALL command retrieves current alarms in the NE.
Table 10-3. RTRV-ALM-ALL Command Parameters
RTRV-ALM-ALL:[tid]:aid_all:[ctag]::[ntfcde],,[srveff],[locn
],[dirn];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aid_all Access identifier. The value is ALL.
[ctag] The correlation tag that links an input command with its associated
output responses. It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ: Major alarm
MN: Minor alarm
Grouping is allowed. If no value is specified, ALL is assumed.
[serveff] Service effect. Valid values are:
SA: Service affecting
NSA: Not service affecting
Grouping is allowed. If no value is specified, ALL is assumed.
[locn] Location of the condition. Valid values are:
NEND: Near end
FEND: Far end
If no value is specified, ALL is assumed.
[dirn] Signal direction. Valid values are:
RCV: Receive
TRMT: Transmit
If no value is specified, ALL is assumed.