Paradyne 4200 - Manual (Page 338)

C. Traps and MIBs
C-14 August 2002 4200-A2-GB20-00
ATM Interface Configuration Parameter Group (RFC 2515)
This group contains information on ATM cell layer configuration of local ATM
interfaces (Backplane and Management Processor) on an ATM device (see
Table C-6, ATM Interface Configuration MIB Group Objects ).
Table C-6. ATM Interface Configuration MIB Group Objects (1 of 2)
Object Description Setting/Contents
atmInterfaceMaxVpcs
(atmInterfaceConf Entry
1)
Maximum number of PVCs
supported on this ATM interface. Integer. Only valid value for all interfaces is
zero.
atmInterfaceMaxVccs
(atmInterfaceConf Entry
2)
Maximum number of VCCs
supported on this ATM interface. Integer. Valid values are:
T ATM1
−
24 interface: 255
T ATM90 interface: 64 (4 multiplied by 24
ports)
T ATM91 interface: 282 (253 pool +
32 defaults + 3 reserved)
atmInterfaceConfVpcs
(atmInterfaceConf Entry
3)
Number of VPCs configured for use
at this ATM interface. Integer. Actual number of VPCs.
atmInterfaceConfVccs
(atmInterfaceConf Entry
4)
This table allows access to contents
of the ARP cache. This table is implemented with read/write
access.
atmInterfaceMaxActiveVpiBits
(atmInterfaceConf Entry
5)
Maximum number of active VPI bits
configured for use on this ATM
interface. Integer. Valid values are:
T ATM1
−
24 interface: 4
T ATM90 interface: 5
T ATM91 interface: 0
atmInterfaceMaxActiveVciBits
(atmInterfaceConf Entry
6)
Maximum number of active VCI bits
configured for use on this ATM
interface. Integer. Valid values are:
T ATM1
−
24 interface: 8
T ATM90 interface: 6
T ATM91 interface: 8
atmInterfaceIlmiVpi
(atmInterfaceConf Entry
7)
The VPI value of the VCC
supporting the ILMI on this ATM
interface. Read-only. Value is zero.
atmInterfaceIlmiVci
(atmInterfaceConf Entry
8)
The VCI value of the VCC
supporting the ILMI on this ATM
interface. Read-only. Value is 16.
atmInterfaceMyNeighborIp
Address (atmInterfaceConf Entry
11)
The value of this object contains the
IP address of the neighbor system
connected to the far end of this
interface. Read-only. Valid values are:
T ATM1
−
24 interface: The IP address
assigned for the purpose of persistent
management of the endpoint.
T ATM90 interface: 0.0.0.0
T ATM91 interface: 0.0.0.0