Paradyne 4200 - Manual (Page 214)

10. Fault Commands
10-22 August 2002 4200-A2-GB20-00
RTRV-ATTR-EQPT
The RTRV-ATTR-EQPT command retrieves current attributes of activities related
to the equipment.
Table 10-13. RTRV-ATTR-EQPT Command Parameters
RTRV-ATTR-EQPT:[tid]:aidall_eqpt:[ctag]::[ntfcde],[cond_eqp
t];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
aidall_eqpt Access Identifier for all equipment. The value is EQPT.
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
[ntfncde] Notification code. Valid values are:
CR: Critical alarm
MJ
:
Major alarm
MN: Minor alarm
NA: Not alarmed (reported via REPORT EVENT)
NR: Not reported (information stored in the NE)
Grouping is allowed. If no value is specified, ALL is assumed.
[cond_eqpt] Equipment condition. Valid values are:
EQPT: Equipment failed self-test
FANALM-1: Fan alarm for Fan 1
FANALM-2: Fan alarm for Fan 2
PROGVR: Failed to load or find requested software or configuration
RMTDLFAIL: Failed to download software or configuration
SWROLLBACK: Software version rolled back
Grouping is allowed. If no value is specified, ALL is assumed.