Paradyne 4200 - Manual (Page 66)

3. ADSL Facility Commands
3-30 August 2002 4200-A2-GB20-00
REPT EVT ADSL
The REPT EVT ADSL message reports current events associated with an ADSL
facility on an LT.
Table 3-24. REPT EVT ADSL Message Parameters (1 of 2)
almcode atag REPT EVT ADSL aid_adsl:cond_adsl,[condeff],
[ocrdat],[ocrtm],[locn],[dirn];[cond_descr];
almcde Alarm code. Identifies the severity of the alarm. The valid value is:
A^: Automatic message (typically reports a cleared alarm)
atag Automatic tag indicating the numerical sequence of messages reported.
aid_adsl Access identifier for the ADSL line(s). Enter in the following format,
replacing lower-case parameters with the values given:
ADSL-rack-shelf-slot-circuit
– rack: Rack Number (1)
– shelf: Shelf Number (1)
– slot: LT Slot Number (1)
– circuit: ADSL circuit on the LT (1
−
24)
cond_adsl ADSL condition. Valid values are:
FACTERM Modem could not initialize (Near End only)
LCD-F: Loss of Cell Delineation (fast) (Near End only)
LOF: Loss Of Frame
LOL: Loss Of Link (Near End only)
LORATE: Line rate is below planned rate (Loss of Signal Quality)
LOS: Loss Of Signal (Near End only)
LPR: Loss of Power (Far End only)
LOFS-L: Loss Of Frame Seconds (line)
LOLS-L: Loss Of Link Seconds (line)
ES-L: Errored Seconds (line)
SES-L: Severely Errored Seconds (line)
UAS-L: Unavailable Seconds (line)
INCRATE-F: Increasing Rate (fast channel). There is no corresponding
standing condition clear message.
DECRATE-F: Decreasing Rate (fast channel). There is no
corresponding standing condition clear message.
LPRS-L: Loss Of Power Seconds (line) (Near End only)
LOSS-L: Loss Of Signal Seconds (line) (Near End only)
[condeff] The effect of the event on the condition reported. Valid values are:
SC: Standing condition raised
CL: Standing condition cleared
ocrdat Date of occurrence in the format mm-dd.