Perle Systems IOLAN SDS - Manual (Page 141)

IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7 141
I/O Commands
Chapter 10
10
This chapter defines all the CLI commands associated with configuring the IOLAN’s I/O parameters.
Global I/O Commands
Set IO UDP
Description Sets the UDP settings for I/O unicast messages.
User Level Admin
Syntax
set io udp [mode on|off]
[broadcast-interval <broadcast_interval>]
set io udp entry 1|2|3|4 disabled
set io udp entry 1|2|3|4 <udp_port> <start_ip> [<end_ip>]
Options mode
Enables/disables UDP broadcast of I/O channel status (data).
broadcast-interval
Enter the interval, in seconds, for UDP broadcasts of I/O channel status (data). Valid
values are 1-9999. Default value is 30 seconds.
entry
You can specify up to four sets of UDP IP address that will receive the I/O unicast.
udp_port
The UDP port that the IOLAN will use to relay messages to servers/hosts.
start_ip
The first host IP address in the range of IP addresses (for IPV4 or IPV6) that the
IOLAN will listen for messages from and/or send messages to.
end_ip
The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)
that the IOLAN will listen for messages from and/or send messages to.