Perle Systems IOLAN SDS - Manual (Page 75)

Line Commands 75
Line Commands
rlogin
Sets the line for a remote login connection.
raw
Creates a connection where no authentication takes place and data is passed unchanged.
telnet
Sets the line for a telnet connection.
ssh
Sets the line for an SSH connection.
reverse
Enables a TCP/IP host to establish a login connection on an external machine attached
to a port. For example, to access machines like protocol converters, statistical
multiplexors, or machines like routers, firewalls, servers, etc.
client-tunnel
Sets the line for a client tunnel connection.
dslogin
The default connection. The IOLAN displays a login on that line. For example,
DSLogin is used when a System Administrator configures the IOLAN, providing
authentication of a user before starting a User Service of SLIP , or users starts a
session(s) from the IOLAN to hosts.
printer
Using the IOLAN as a printer server. For example, remote printing using LPD (port
515) or RCP (port 514).
ppp
Sets the port to a dedicated PPP line.
slip
Sets the port in SLIP mode.
udp
Sets the line to listen for and/or send UDP data.
vmodem
The IOLAN port behaves as if it were a modem to the attached device.
server-tunnel
Sets the line for a server tunnel connection.
modbus-master
Sets the line to act as a Modbus master.
custom-app
Sets the line to use the custom application created with the SDK.
power-management
Indicates that there is a power bar connection to this serial line.
trueport
Sets the line to communicate with the TruePort utility. You must install the TruePort
utility on the host machine.