Perle Systems IOLAN SDS - Manual (Page 70)

Line Commands
70 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7
keepalive
Enables a per-connection TCP keepalive feature. After the configured number of
seconds, the connection will send a gratuitous ACK to the network peer, thus either
ensuring the connection stays active OR causing a dropped connection condition to be
recognized.
This parameter needs to be used in conjunction with server parameter,
monitor-connection-every. The interval determines how long the IOLAN will wait
during inactivity before "testing" the connection. It should be noted that if a network
connection is accidentally dropped, it can take as long as the specified interval before
anyone can reconnect to the serial port.
lock
When enabled, the user can lock his terminal with a password using the Hotkey Prefix
(default Ctrl-a) ^a l (lowercase L). The IOLAN prompts the user for a password and a
confirmation.
microsoft-sac-support
When enabled, the user can lock his terminal with a password using the Hotkey Prefix
(default Ctrl-a) ^a l (lowercase L). The IOLAN prompts the user for a password and a
confirmation.
motd
Enables/disables the message of the day on the line.
multisessions
This parameter defines the maximum number of additional reverse sessions which will
be allowed for this line allowing more control as to how the total reverse sessions are
allocated. This is on top of the main reverse session to the line.
The total number of reverse sessions on the IOLAN are dependent on the model:
z 1-port: 0-3
z 2-port: (4 x #-of-ports) -1
z STS/SDS/MDC 4+ ports: (2 x #-of-ports) -1
z SCS 4+ ports: (2 x (#-of-ports + 1)) -1
user
For DSLogin line service, makes this a line that is dedicated to the specified user. Only
this user will be able to log in on this line and they won’t need to enter their login name
- just their password. When the Line Service is set to Direct or Silent Rlogin , the User
parameter is used as the Rlogin user name (since Rlogin will not prompt you for a user
name).
nouser
Blanks out the User parameter, in case you want to change a dedicated user line to an
undedicated line.
reset
Resets the terminal type connected to the line when a user logs out.
dial-timeout
The number of seconds the IOLAN will wait to establish a connection to a remote
modem. The default value is
45 seconds.
dial-retries
The number of times the IOLAN will attempt to re-establish a connection with a remote
modem. The default value is 2 .