Set termtype, Set user, Set termtype set user – Perle Systems IOLAN SDS User Manual
Page 53
User Commands 53
Commands for Users Logged Into the IOLAN
Set Termtype
Set User
Description Sets the type of terminal being used for the current session.
User Level Normal, Admin
Syntax
set termtype
wyse60|vt100|ansi|dumb|tvi925|ibm3151te|vt320|hp700|term1|term2|
term3
Option
wyse60|vt100|ansi|dumb|tvi925|ibm3151te|vt320|hp700|term1|term2|term3
Specifies the type of terminal connected to the line:
z
Dumb
z
WYSE60
z
VT100
z
ANSI
z
TVI925
z
IBM3151TE
z
VT320 (specifically supporting VT320-7)
z
HP700 (specifically supporting HP700/44)
z
Term1, Term2, Term3 (user-defined terminals)
Description Sets the current users settings.
User Level Normal, Admin
Syntax
set user . [hotkey-prefix <00-7f>] [language english|customlang]
[routing none|send|listen|send-and-listen] [password]
Options
hotkey-prefix
The prefix that a user types to control the current session. The default value is
hex 01
,
which corresponds to
Ctrl-a
(
^a
) (hex value 02 would be Ctrl-b (^b), etc.):
z
^a number
—To switch from one session to another, press
^a
and then the required
session number. For example,
^a 2
would switch you to session 2. Pressing
^a 0
will return you to the IOLAN Menu.
z
^a n
—Display the next session. The current session will remain active. The lowest
numbered active session will be displayed.
z
^a p
—Display the previous session. The current session will remain active. The
highest numbered active session will be displayed.
z
^a m
—To exit a session and return to the IOLAN. You will be returned to where
you left off. The session will be left running.
z
^a l
—(Lowercase L) Locks the line until the user unlocks it. The user is prompted
for a password (any password, excluding spaces) and locks the line. Next, the user
must retype the password to unlock the line.
z
^r
—When you switch from a session back to the Menu, the screen may not be
redrawn correctly. If this happens, use this command to redraw it properly. This is
always
Ctrl R
, regardless of the
Hotkey Prefix
.
The
User Hotkey Prefix
value overrides the
Line Hotkey Prefix
value. You can use the
Hotkey Prefix
keys to lock a line only when the line
Lock
parameter is
On
.
language
You can specify whether a user will use
English
or
Customlang
as the language that
appears in the Menu, CLI, or WebManager. The IOLAN supports one custom language
that must be downloaded to the IOLAN; otherwise,
Customlang
defaults to English.