Perle Systems IOLAN SDS - Manual (Page 22)

Server Commands
22 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7
dhcp-update-dns
The DHCP server will update the DNS server when the IOLAN requests a DHCP IP
address (the communication between the DNS server and the DHCP server must
already be set up in your network).
dhcp/bootp
Enables the DHCP/BOOTP client process in the IOLAN. By default, this is
disabled/off. If this is enabled, the server IP address parameter is disabled.
domain
Unique name for your domain, your location in the global network. Like Hostname, it is
a symbolic, rather than a numerical, identifier.
domain-prefix
(SCS models only) A domain prefix to uniquely identify the Ethernet interface to the
DNS when the IOLAN has two Ethernet interfaces. The format of the Ethernet interface
will take the form of <Server Name>.<Domain Prefix>.<Domain Name> or <Server
Name>.<Domain Prefix>, depending on what is configured.
flush-on-close
When enabled, deletes any pending outbound data when a port is closed; as opposed to
maintaining the port to send pending data. The default value is
Off .
internet
The IOLAN’s unique IPv4 network IP address. If you are using the IOLAN in an IPv6
network, use the set ipv 6 command.
internet [eth1|eth2]
Dual Ethernet SCS models require that you specify which Ethernet connection you are
setting, either eth1 or eth2 .
name
You must supply a name for the IOLAN.
netmask
The network subnet mask. For example, 255.255.0.0.
line-menu-string
The string used to access to the Easy Port Access menu without disconnecting the initial
reverse SSH or reverse Telnet session.The default string is ~menu .
monitor-connection-every
Specify how often, in seconds, the IOLAN will send a TCP keepalive. This only applies
to line service types that support the keepalive feature. The default interval is every 30
seconds
oem-login
When set, and a custom language file is in use, the login prompt will use the string
defined in the language file as the login prompt instead of the default prompt, login: .