Perle Systems IOLAN SDS - Manual (Page 95)

Line Commands 95
Line Service Commands
Set Multihost Line
Set Line Initiate-Connection
Show Custom-App
Show Interface
Show Power-Management
Description Configures multiple hosts or a primary/backup host schema for Silent Raw, Reverse
Raw, or Client-Inititated TruePort service types (multihost must be enabled by the line
service type for this to take effect, see Set Line Service on page 73 for the command to
enable multihost).
User Level Admin
Syntax
set multihost line <number> entry <number> host <host> <TCP_port>
set multihost line <number> entry <number> delete
Options entry
You can specify up to 49 hosts in the multihost table.
host <host>
Specify the preconfigured host that will be in the multihost list.
<TCP_port>
Specify the TCP port that the IOLAN will use to communicate to the Host .
delete
Deletes the specified entry from the multihost table.
Description Determines how the connection is initiated for Direct Telnet, Direct SSH, Direct Raw,
and Direct Rlogin.
User Level Admin
Syntax
set line <number>|* initiate-connection
any-char|specific-char <hex>
Options any-char
Initiates a connection to the specified host when any data is received by the serial port.
specific-char <hex>
Initiates a connection to the specified host only when the specified character is received
by the serial port.
Description Shows the custom application line settings.
User Level Admin
Syntax
show custom-app line .|<number>|*
Description Shows the network interface information.
User Level Admin
Syntax
show interface [brief|ppp|slip|ethernet]
Description Shows the power management settings for a line.
User Level Admin
Syntax
show power-management line <number>