Perle Systems IOLAN SDS User Manual
Page 61
User Commands 61
Configuring Users
level
The access that a user is allowed:
z
Admin—The admin level user has total access to the IOLAN. You can create more
than one admin user account but we recommend that you only have one. They can
monitor and configure the IOLAN.
z
Normal—The Normal level user has limited access to the IOLAN. Limited CLI
commands and Menu access are available with the ability to configure the user’s
own configuration settings.
z
Restricted—The Restricted level user can only access predefined sessions or
access the Easy Port Access menu.
z
Menu—The menu level user will only be able to access predefined session or
access the Easy Port Access menu. The Easy Port Access allows the user to
connect to the accessible line without disconnecting their initial connection to the
IOLAN. Does not have any access to CLI commands.
netmask
This is used for the PPP or SLIP Service types. Only used for IPv4. If the remote user
is on a subnet, enter the network’s subnet mask. For example, a subnet mask of
255.255.0.0.
line-access
Specifies the user access rights to each IOLAN device line. Options are:
z
Read/Write—Users are given read and write access to the line.
z
Read In—Users are given access to read only outbound data, data that is going
from the IOLAN to the device.
z
Read Out—Users are given access to read only inbound data, data that is going
from the device to the IOLAN.
Users can read data going in both directions by selecting both the
Read In
and
Read
Out
options. The
on|off
option is only for 1-port models. You can disable line access
in 2-port + models by specifying
0
(zero).
phone-number
The phone number the IOLAN will dial to callback the user (you must have set
Callback
to
On
). Enter the number without spaces. To change the phone number,
overwrite the previous entry; to clear the phone number, set it to
""
(double quotes
without a space).
routing
Determines the routing mode used for RIP packets on the PPP and SLIP interfaces for
this user. Values are:
z
None—RIP packets are neither received nor sent by the IOLAN.
z
Send—RIP packets can only be sent by the IOLAN.
z
Listen—RIP packets can only be received by the IOLAN.
z
Send and Listen—RIP packets are sent and received by the IOLAN.
service
The type of service that the user will use.