Perle Systems IOLAN SDS - Manual (Page 83)

Line Commands 83
Line Service Commands
netmask
The network subnet mask. For example, 255.255.0.0. If your user is authenticated by
RADIUS and the RADIUS parameter Framed-Netmask is set in the RADIUS file, the
IOLAN will use the value in the RADIUS file in preference to the value configured
here.
password
This field defines the password which is associated with the user defined by the user
parameter. It is used to authenticate a user connecting to the IOLAN. You can enter a
maximum of 16 alphanumeric characters.
proto-comp
This determines whether compression of the PPP Protocol field takes place on this link.
The default is
On .
ripaddr
The IPV4 IP address of the remote end of the PPP link. Choose an address that is part
of the same network or subnetwork as the IOLAN. If you set the PPP parameter IP
Address Negotiation to On, the IOLAN will ignore the remote IP address value you
enter here and will allow the remote end to specify its IP address. If your user is
authenticated by RADIUS and the RADIUS parameter Framed-Address is set in the
RADIUS file, the IOLAN will use the value in the RADIUS file in preference to the
value configured here. The exception to this rule is a Framed-Address value in the
RADIUS file of 255.255.255.254 ; this value allows the IOLAN to use the remote IP
address value configured here.
roaming-callback
A user can enter a telephone number that the IOLAN will use to callback him/her. This
feature is particularly useful for a mobile user. Roaming callback can only work when
the User Callback parameter is set to On . Roaming callback therefore overrides (fixed)
User Callback .To use Roaming Callback , the remote end must be a Microsoft
Windows OS that supports Microsoft’s Callback Control Protocol (CBCP). The user is
allowed 30 seconds to enter a telephone number after which the IOLAN ends the call.
The default is
Off .
routing
Determines the routing mode (RIP, Routing Information Protocol) used on the PPP
interface as one of the following options:
z None—Disables RIP over the PPP interface.
z Send—Sends RIP over the PPP interface.
z Listen—Listens for RIP over the PPP interface.
z Send and Listen—Sends RIP and listens for RIP over the PPP interface.
This is the same function as the Framed-Routing attribute for RADIUS authenticated
users. Default is None .
rpassword
The rpassword is the password which is associated with the user defined by ruser . It
is used to authenticate a user connecting to the IOLAN. You can enter a maximum of
16 alphanumeric characters.