Perle Systems IOLAN SDS - Manual (Page 82)

Line Service Commands
82 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7
ipaddr-neg
Specifies whether or not IP address negotiation will take place. IP address negotiation is
where the IOLAN allows the remote end to specify its IP address. The default value is
Off . When On , the IP address specified by the remote end will be used in preference to
the Remote IP Address set for a Line . When Off , the Remote IP Address set for the
Line will be used.
ipv6-global-network-prefix
You can optionally specify an IPv6 global network prefix that the IOLAN will advertise
to the device at the other end of the PPP link. Enter the IPv6 network prefix in the
aaaa:bbbb:cccc:dddd:: format.
ipv6-local-interface
The local IPv6 interface identifier of the IOLAN end of the PPP link. For routing to
work, you must enter a local IP address. Choose an address that is part of the same
network or subnetwork as the remote end. Do not use the IOLAN’s (main) IP address in
this field; if you do so, routing will not take place correctly. The first 64 bits of the
Interface Identifier must be zero, therefore, ::abcd:abcd:abcd:abcd is the expected
format.
ipv6-remote-interface
The remote IPv6 interface identifier of the remote end of the PPP link. Choose an
address that is part of the same network or subnetwork as the IOLAN. If you set the
PPP parameter IP Address Negotiation to On , the IOLAN will ignore the remote IP
address value you enter here and will allow the remote end to specify its IP address. If
your user is authenticated by RADIUS and the RADIUS parameter
Framed-Interface-ID is set in the RADIUS file, the IOLAN will use the value in the
RADIUS file in preference to the value configured here. The first 64 bits of the
Interface Identifier must be zero, therefore, ::abcd:abcd:abcd:abcd is the expected
format.
lipaddr
The IPV4 IP address of the IOLAN end of the PPP link. For routing to work, you must
enter a local IP address. Choose an address that is part of the same network or
subnetwork as the remote end; for example, if the remote end is address
192.101.34.146, your local IP address can be 192.101.34.145. Do not use the IOLAN’s
(main) IP address in this field; if you do so, routing will not take place correctly.
magic-neg
Determines if a line is looping back. If enabled ( On ), random numbers are sent on the
link. The random numbers should be different, unless the link loops back. The default is
Off .
mru
The Maximum Receive Unit (MRU) parameter specifies the maximum size of PPP
packets that the IOLAN’s port will accept. Enter a value between 64 and 1500 bytes; for
example, 512. The default value is 1500 . If your user is authenticated by the IOLAN,
the MRU value will be overridden if you have set a Framed MTU value for the user. If
your user is authenticated by RADIUS and the RADIUS parameter Framed-MTU is set
in the RADIUS file, the IOLAN will use the value in the RADIUS file in preference to
the value configured here.
nak-retry
The maximum number of times a configure NAK packet will be re-sent before the
link is terminated.