Printronix L5020 - Manual (Page 103)

Loading Flash Memory (If Equipped)
103
51. Download the files to the printer by using the DOS copy
command. You can download the files one at a time by entering
one file name per DOS
copy command. Alternatively, you can
copy multiple files in one copy command.
To download one file at a time, enter the following at the DOS
prompt, for example:
copy /b file_name.dwn LPT1 <Return>
To download multiple files, enter the following at the DOS
prompt, for example:
copy /b file_name1.dwn+file_name2.dwn+... LPT1
<Return>
NOTE: The above command examples assume that LPT1 is used
as the download port from the computer, and that the
printer is already in download mode, waiting for file
download, before you copy the files to the printer. If you are
downloading the files using the LPT2 port on the computer,
substitute “LPT2” for “LPT1” in the above commands.
52. While the files are being copied into memory, the printer LCD
informs you of the load process and status. (Messages are
listed in the table following this section.)
53. Wait until the new files have successfully loaded into printer
memory.
54. If you have any more software to install (logo, form, TIFF,
setup, or font files), go back to step 43.
55. When all of the new software has successfully loaded into
memory and the printer has reset itself, set the printer power
switch to O (off).
56. Remove the diskette(s) from the computer and store them with
the printer.
57. If you had to install a parallel data cable to the computer and
printer in step 11, continue with step 58. If not, skip to step 63.
58. Unplug the printer AC power plug from its electrical outlet.
59. Power off the computer.