Printronix L5020 - Manual (Page 46)

Chapter 3 Printer Configuration
46
Factory Settings
The following table lists the factory set configuration defaults.
These values are available for loading at any time, and are
maintained in the printer until a new configuration is loaded.
Paper Control
Image Width 14.6 inches
Form Length 11.0 inches
Paper Length Auto. Select
Fanfold Output Into stacker
Horizontal Image Shift 0/100 inches
Vertical Image Shift 0/100 inches
Toner 3
Reprint on Fault Enable
Paper Type Standard
Burst on Eject Enable
Mode LinePrinter+
Config. Control
Load Configuration 0
Save Configuration 1
Print Configuration Current
Delete Configuration 1
Power-up Configuration 0
Protect Saved Configuration Disable