Printronix L5020 - Manual (Page 80)

Chapter 3 Printer Configuration
80
Series 1 Poll
Values: The allowable range is 0 through 255. The default value for
this parameter is 0.
This parameter selects the character that the printer recognizes as
the Series 1 poll character.
NOTE: This parameter is used only with the SERIES 1, 1 CH and
SERIES 1, 2 CH protocols. See the description of the Host
Protocol menu option on page 75 for more information.
Series 1 Delay
Values: 0+ Msec, 15+ Msec, or 30+ Msec. The default value for
this parameter is 0+ Msec.
This parameter selects the Series 1 delay time, in milliseconds, that
the printer waits prior to sending the Series 1 response to the host.
NOTE: This parameter is used only with the SERIES 1, 1 CH and
SERIES 1, 2 CH protocols. See the description of the Host
Protocol menu option on page 75 for more information.
Series 1 Idle
Values: Enable or Disable. The default value for this parameter is
Disable.
If you enable the Series 1 Idle parameter, then whenever the buffer
is less than 75% full, the printer sends a response character to the
host every two seconds.
NOTE: This parameter is used only with the SERIES 1, 1 CH and
SERIES 1, 2 CH protocols. See the description of the Host
Protocol menu option on page 74 for more information.