Printronix L5020 - Manual (Page 96)

Chapter 3 Downloading Into Flash Memory
96
7. To convert a setup file, enter the following at the DOS prompt,
for example:
lasr2fls setup.ptx setup.dwn setup.ptx A
<Return>
where setup.ptx is the name of one of the setup files you
want to convert. This command converts the specified setup
file, creating the downloadable file
setup.dwn .
8. Repeat step 7 for any additional setup files to be converted.
9. To convert other kinds of files (a logo or form file, for example),
enter the following at the DOS prompt, for example:
lasr2fls my_logo.xxx my_logo.dwn my_logo.xxx A
<Return>
where my_logo.xxx is the name of one of the form or logo
files you want to convert. This command converts the specified
logo or form file, creating the downloadable file
my_logo.dwn .
10. Repeat step 9 for any additional logo and form files to be
converted.
11. Proceed to the next section to download the converted files.
IMPORTANT Be sure that you always enter the “A” parameter on the
lasr2fls command line, as indicated above.
Downloading Into Flash Memory
CAUTION When downloading an emulation to a virtual printer, all other
optional font files, customer-supplied logos, and setup files
will be erased. You will then need to reload these files. Before
starting a download procedure, be sure that you have all of the
necessary installation files on hand.
To download emulation software, as well as downloadable files for
logos, forms, TIFF, setup, and fonts to the printer, do the following: